Ge-industrial-solutions EntelliGuard G Electrical close switch User Manual download pdf

Introduction

Electrical close switch:

Electrical close switch is an optional accessory

which can be used in combination with the

command Close coil. It has an extra ‘ON’ push

button that fits onto the breaker front fascia,

which can be locally operated manually to close

the breaker.

Figure 1.

Catalog Number: GECPR

Table 1. Electrical close switch push button can be

used with the below Command close coils

Catalog No DC Voltage AC Voltage

GCCC024DR 24V

GCCC030DR 30V

GCCC048R 48V 48V

GCCC060DR 60-72V

GCCC120R 110-130V 110-130V

GCCC208AR 208V

GCCC240R 220-240V 220-240V

DEH-41374 Installation Instructions

EntelliGuard

G Circuit Breaker

Accessories

Electrical close switch

WARNING: Before installing any accessories, turn the

breaker OFF, disconnect it from all voltage sources,

and discharge the closing spings.

AVERTISSEMENT: Avant d’installer tout accessoire,

mettre le disjoncteur en position OFF, le déconnecter

de toute tension d’alimentation , et décharger les

resorts d’armement

Use the following procedure to install the

Command Closing Coil accessory into the circuit

breaker.

1. Turn the breaker off and discharge the closing

springs by depressing the OFF and ON buttons in

the sequence OFF-ON-OFF. Verify that the

breaker OFF-ON indicator shows OFF on a green

background and that the charge indicator shows

DISCHARGE on a white background. If installing

in a draw-out type breaker remove breaker from

adaptor (cassette) before continuing.

2. Loosen the 6 screws on front cover (fascia)

using a posidrive screw driver as shown in Fig 1.B

Rotate the charging handle down and slide the

front cover over the handle to remove the front

cover as shown in Fig. 1.C.

1 2 3 4

Summary of Contents

Page 1

Introduction Electrical close switch: Electrical close switch is an optional accessory which can be used in combination with the co

Page 2

Figure 2. (A) Front Cover (B) ScrewRemoval (C) Handle Rotation 3. Slide the switch assembly over the mechanism side sheet and locate in the two l

Page 3

8. Insert the push button and the spring from the front of the fascia. Assemble them to the fascia with the screw & washer as shown in fig 8.

Page 4

Reference: Command Closing Coil Connection Scheme: These instructions do not purport to cover all details or variations in equipment nor, to

Comments to this Manuals

No comments

Ge-industrial-solutions EntelliGuard G Electrical close switch User Manual

Browse online or download User Manual for Equipment Ge-industrial-solutions EntelliGuard G Electrical close switch. GE Industrial Solutions EntelliGuard G Electrical close switch User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Ge-industrial-solutions EntelliGuard G Electrical close switch