Ge-industrial-solutions Galaxy Verification User Manual download pdf (Page 58)

Galaxy Power System Verification Procedures

3 - 14 Galaxy Millennium Controller Performance Verification Procedures Issue 3 January 2008

Fuse Alarm Test

Introduction If there are any site installed fuses, they can be tested for alarm

functionality by generating alarms for the controller at these points. If

this is not possible, they can be tested by simulating alarm conditions at

the BSL board (see Figure 3-1) on the Millennium Controller by

following the steps given below.

Major Fuse Alarm

(FAJ)

Connect a jumper (through a 1K resistor) between Pin 63 (FAJ) and

Pin 93 (ABS) on BSL Board (see Tables 3B, 3C and 3D in the

Millennium controller manual for details of these pin assignments).

DIST and MAJ LEDs will light up. MJF default relay will be activated.

For GPS cabinets, fuse alarms may be simulated at the BNL1 or BL7

alarm card by strapping FAJ on these cards to the hot bus (P4-1 for

BNL1, P5-6 for BNL7).

Minor Fuse Alarm

(FAN)

Connect a jumper (through a 1K resistor) between Pin 65 (FAN) and

Pin 93 (ABS) on BSL Board (see Tables 3B, 3C, and 3D in the

Millennium controller manual for details of these pin assignments).

DIST and MIN LEDs will light up. MNF default relay will be activated.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 101 102

No comments

Ge-industrial-solutions Galaxy Verification User Manual Page 58